The Location of the Area on each Artifact Where PIXE Analysis was Undertaken
PHASE I
33-21-041, Awl
15 mm from blunt end
33-15-079, Awl?
37 mm from tip
33-15-078, Blade
15 mm from broken end of tang
33-15-086, Dagger
18 mm from end, on side of tang
33-21-175, Knife blade
50 mm from tip, on side of blade
33-21-176, Knife blade
On metallographic section, cut from edge of blade, 30 mm from head of tang
33-21-179, Knife blade
62 mm from broken end of tang
33-21-190, Nail head
Cut across the fragmented shaft
33-21-191, Needle
Cut from the end of the longest of four fragments
33-15-082, Pin
35 mm from head
33-15-080, Pin, head missing
On side of thick, small fragment
33-15-084, Pin, hemiconoidal head
36 mm from head
33-21-181, Pin, hemiconoidal head
137 mm from tip, on side of shaft
32-21-182, Pin, hemiconoidal head
39 mm from head, on side of shaft
33-15-085, Pin, pyramidal head
74 mm from tip
33-21-188, Pin, pyramidal head
43 mm from head, on side of shaft
33-21-183, Pin, pyramidal head
90 mm from tip, on side of shaft
33-15-083, Pin, pyramidal head
63 mm from head
33-21-187, Rod fragment
35 mm from tip
33-21-186, Rod fragment
On metallographic section, cut from the tip
33-21-039, Wire, heavy & square
On metallographic section, cut from one of three fragments
PHASE II
33-22-554, Anklet
7 mm from one end
33-22-553, Anklet
40 mm from one end
33-22-555, Anklet
93 mm directly across from tip
33-21-389, Bar, tapered
47 mm from blunt end
33-21-386, Blade
35 mm from end of tang
33-22-569, Bracelet
60 mm directly across from one end
33-22-556, Bracelet
18 mm from one end
33-22-557, Bracelet
51 mm directly across from one end
33-22-558, Bracelet
49 mm directly across from one end
33-15-411, Bracelet
44 mm directly across from one end
33-15-409, Bracelet
63 mm directly across from the pointed end
33-22-560, Bracelet (2 corroded together)
45 mm directly across from the exposed end
33-22-559, Bracelet (2 corroded together)
50 mm directly across from the exposed end
33-22-570, Bracelet, 1+ coils
54 mm across from one end
33-22-552, Bracelet, 1.5 coils
45 mm directly across from one end
33-15-410, Bracelet, 1.5 coils
10 mm from one end
33-22-551, Bracelet, 1.75 coils
18 mm from one end
33-15-405, Bracelet, 4+ coils
50 mm directly across from one end
33-22-574, Bracelet, 5 coils
65 mm directly across from one end
33-15-391, Chisel (cleaned)
56 mm from blunt end
33-21-390, Nail, concave head
23 mm from tip of shaft
33-22-542, Nail, flat-topped head
40 mm from flat top
33-22-544, Needle shaft
10 mm from thicker, broken end
33-22-543, Pendant or stamp seal
25 mm from pendant loop
33-22-547, Pin, double spiral head
45 mm from fragmented tip of shaft
33-21-392, Pin, hemiconical head (two fragments)
On the edge of the head
33-21-387, Pin, pyramidal head
18 mm below head, on the shaft
33-15-396, Spiral fragment
21 mm from top loop
33-15-401, Tube
4 mm from sound end
PHASE III
33-15-590, Anklet
33 mm from blunt whole end
33-21-949, Anklet
82 mm across from the two ends
33-22-332, Arrowhead or spatula?
27 mm from tip, on blade
33-22-328, Awl fragment?
34 mm from tip
33-22-111, Blade
25 mm from tip, on blade
33-22-312, Bracelet, 3.5 coils
Metallographic section cut from one end, surface PIXE 48 mm directly across from that end
33-21-623, Bracelet, 7 coils
60 mm directly across from one end
33-21-911, Chisel
On end of fragmented shaft
33-22-293a, Coils, tapered (two)
18 mm directly across from one end
33-22-182, Cosmetic stick
On blunt end of shaft
33-22-343a, Cosmetic stick, head
Top of the left hand curl on the head
33-22-343e, Cosmetic stick, tip
Side of blunt tip
33-15-728, Cosmetic stick with head
30 mm from shaft end
33-22-117, Cosmetic stick, head
103 mm from shaft end, below the head
33-22-335, Gouge, tip only
On surface of fragmented end
33-21-985, Ingot
65 mm from rounded end, on the flatter side, towards the edge
33-21-986, Ingot fragment
Metallographic section cut from narrow end
33-21-910, Knife blade
16 mm from top loop
33-22-343c, Small amorphous mass
On the exposed surface
33-22-114, Model mattock
On blunt end of shaft
33-15-576, Nail, flat-topped head
74 mm from tip
33-21-915, Needle
66 mm from tip
33-15-585, Ornament (blade?)
7 mm from coil decoration
33-22-322, Pin, conoidal head, bent
32 mm from tip
33-15-578, Pin, hemiconoidal head
18 mm from head, on side of the shaft
33-15-732, Pin, hemiconoidal head
132 mm from head, on shaft
33-15-579, Pin, pyramidal head
55 mm from broken tip on shaft
33-22-323, Pin, wire loops as head
34 mm from tip
33-22-116c, Ring of spindle
On small, inner “V” of decoration
33-22-343d, Small rings (pair of)
On the exposed side of the lower ring
33-22-116a, Rod or spindle
144 mm from tip
33-22-113, Shafthole double axe
On rim of shaft
33-22-112, Shafthole mattock
On rim of shaft
33-15-570, Spearhead
15 mm from base of tang
33-15-568, Spearhead
8 mm from collar of the tang
33-21-907, Spearhead
40 mm from top of tang, cut at 75 mm from tip on one edge
33-21-908, Spearhead
37 mm from top of tang
33-21-906, Spearhead
At the join of the blade and the tang
33-22-129b, Spiral pendants (two fragments)
On larger coil, 2 mm in from loop
33-21-919, Tube
23 mm from fragmented end
33-22-116b, Whorl of spindle
On lower flat surface near edge
33-22-343b, Tightly packed, small coils
On the surface of several loops
33-15-455, Ornament (sheet metal)
On the outer surface, 3 cm from the fragmented edge
33-15-694, Bracelet, double spiral
On the side, about 1 cm from one blunt end